Interchangeable Barrels
This is a simple way to make interchangeable barrels. There are better ways, but here is probably the most simple. This is based on 1.5" male thread on your gun. I am not going to explain any other sizes, as it is pretty self explanatory. If your gun is built with a solid barrel, just chop it off and put a threaded adapter on it.
1 1/2" PVC Barrel
Materials
(1) 3 ft 4 in piece of 1 1/2" SCH 40 PVC
(2) 1 1/2" Threaded Female Adapter.
1 1/4" PVC Barrel
Same as above only smaller.
Materials
(1) 3 ft 4 in piece of 1 1/4" SCH 40 PVC
(2) 1 1/2" Threaded Female Adapter.
(3) 1 1/2" to 1 1/4" reducer bushing
1" PVC Barrel
Same as above only smaller.
Materials
(1) 3 ft 4 in piece of 1" SCH 40 PVC
(2) 1 1/2" Threaded Female Adapter.
(3) 1 1/2" to 1 1/4" reducer bushing
(4) 1 1/4" to 1" reducer bushing
3/4" PVC Barrel
Same as above only smaller.
Materials
(1) 3 ft 4 in piece of 3/4" SCH 40 PVC
(2) 1 1/2" Threaded Female Adapter.
(3) 1 1/2" to 1 1/4" reducer bushing
(4) 1 1/4" to 1" reducer bushing
(5) 1" to 3/4" reducer bushing
1/2" PVC Barrel
Same as above only extremely small.
Materials
(1) 3 ft 4 in piece of 1/2" SCH 40 PVC
(2) 1 1/2" Threaded Female Adapter.
(3) 1 1/2" to 1 1/4" reducer bushing
(4) 1 1/4" to 1" reducer bushing
(5) 1" to 3/4" reducer bushing
(6) 3/4" to 1/2" reducer bushing
*Cost goes up as barrel size goes down because there are more fittings.
*To attach the barrels to the Green Hornet, just screw them on.